5 Uses For Services

Posted on Posted in Home Products & Services

How To Install a Garage Door the old door of the garage should be first removed using the instructions in the manufacturer’s manual, this is undertaken by unlatching the door from its pulley system, before unscrewing the tracks, the door panels are set apart, one panel is removed at a time so that it does not fall on someone The areas where the door is supposed to be installed are then measured, these are; the door-opening height and width, the headroom from the top of opening to ceiling, and the back room which is the length of the garage, having done the proper measurements, the stops temporarily attach to both sides of the opening, making sure they are flush with the inside edge of the door jamb, the bottom piece of the new door is laid out using the sawhorses, if necessary any required weather stripping is attached, any hinges that are necessary are additionally attached and handles lifted to piece setting it properly using a level, the bottom piece is inserted into the door frame, the tap nails then partway into each jamb, to secure them in place the nails are bent slightly then using manufacturer’s instructions, the vertical, horizontal and curved pieces of the track are then assembled and then set aside the second panel should be installed on top of the first panel, onto the side jambs nails are then hammered until they are well held in place, after this hinges are installed, repetition of this process then takes place depending number of panels, it is however required that each if the pieces are attached to the door jamb, this is the fourth step of installing a new garage door
The Key Elements of Great Doors
after securing all sections, rollers are then installed in the section that does support them after which they are placed in the assembled track, as one goes along the brackets of the tracks are secured, the rollers should not be pressed too tightly against the track to avoid friction which damages the door during usage
What No One Knows About Repairs
when the vertical tracks are well secured against the jambs, installation of the curved and horizontal pieces takes place, the previous measurements are used when installing the horizontal pieces, the tracks should be levelled in order to make sure they are straight and they should point 90 degrees away from the opening, according to the manufacturer’s instructions springs are then assembled, when attaching the springs to the pulley, the door is lifted to half length and then pulled up the remaining distance, that is basically how to install a garage door